We will introduce to you what is the allowable error range of the commonly used flat steel for toothed grille?
The zinc coating is too thin. If omitting pickling or vulcanization, the price that the customer wants cannot be achieved, and the galvanized layer will be reduced (the galvanized layer is too thin), and the hot-dip galvanized grid will be rusted.
Galvanized grating with a flat steel distance of 30mm is the most widely used type in the industry. Among the commonly used series, it has the strongest resistance to surface impact
Because there must be an environmental protection system in the spray booth, the water curtain and adsorption treatment are generally used, which means that there will be a lot of water Therefore, the ground of the pool must use a grid plate, so as to ensure that the sewage will not accumulate on the surface and make it impossible to walk. It is enough to install the corresponding drainage equipment under the grid plate.
The grid plate is now a step closer in the environmental protection industry. The pavement of the channel grid plate in the sewage treatment plant, the stairs are placed on the grid plate, and sometimes water treatment is required. It can be used for a short period of time with other products, and the grid plate is used for a long period of time. In urban construction, the grid plate is used as a roadside wall. It has been used in foreign countries in the early stage. The cost may be higher than average, but the years are long-term use and the current development is not bad.
The above is what is the allowable error range of the commonly used flat steel for toothed grating plates? The related introduction, I hope it will help you to buy the toothed grille.
Inquiry for Our Product
Hongkong Royce Metal Products Co., Ltd.
E-mail: [email protected]
When you contact us, please provide your detail requirements. That will help us give you a valid quotation.
Royce steel gratings can meet ASTM, AS, BS, DIN, EN, GOST standard . We can design non-standard steel grating according to the sketches and drawings. In addition, if you are not satisfied with the products received, we also have perfect after-sales service.
Unit A1, 7/F, Cheuk Nang Plaza,250 Hennessy Road, Wanchai, Hong Kong
Copyright © 2000- Hongkong Royce Metal Products Co., Ltd.